Make A Bridge Rectifier From Diodes
Make A Bridge Rectifier From Diodes
Make your own single or multi phase bridge rectifier from diodes
wind | electric circuitThe electricity generated by most
wind turbine generators is
alternating current (AC). To use this to charge batteries or power most lighting and devices directly, it must be
rectified into
direct current (DC).
The simplest
bridge rectifier is made up of just four
diodes (components which allow electricity to flow in just one direction). The diagram below (taken from our
Introduction to Bridge Rectifiers) shows how the four diodes are wired together and also shows how electricity flows through it as the current
alternates.
Three Phase Bridge Rectifiers
Typically
wind turbines do not generate single phase AC (displayed in the above example), but instead generate multi-phase AC - usually three-phase AC electricity.
To better understand the basic principles of three phase electricity please click here.
Therefore, more diodes are required to rectify the three phases of electricity - in fact six are required and must be wired up as shown in the diagram below.
Why Make Your Own Bridge Rectifier?
It is possible to purchase complete
bridge rectifiers cheaply with current ratings from below 1 Amp to as much as 35 or 50 Amps. To make a three phase bridge rectifier is a simple case of wiring them together and then to each of the three phases of generated electricity. Click here to find out how to
make a bridge rectifier in this way.
Pictured above is an example of a
35A bridge rectifier (available for sale through this website). Bridge rectifiers rated above 35A or 50A suddenly become very expensive. Therefore if your wind turbine has a total maximum output current of more than 25-30 Amps, it is worthwhile making your own
bridge rectifier with high power rated
diodes wired as shown above but fitted to a suitably large heatsink.
High Current High Voltage Diodes
Diodes are available in a massive range of voltages and currents. Here is a list of some example diodes which can be used in bridge rectifiers for high current applications:
1N4045 Rectifier Diode - rated up to 275 Amps at voltages of up to 100 Volts. These are particularly suitable for 12V wind turbines which will not exceed 100 Volts, but may generate high currents. The
1N4045 datasheet (PDF 99 kB) can be downloaded here.
MBR7030WT Schottky Power Rectifier - rated up to 70 Amps and 30 Volts. These are again suitable for many 12V wind turbines and are avaibale for just a couple of pounds each.
MBR7030WT datasheet
(PDF) is available here.
DD171N14K Dual Power Module - rated at up to 1400 Volts and 171 Amps. These would be suitable for almost any domestic wind turbine.
Article Last Modified: 15:33, 2nd Feb 2007Comment on this Article
If you have any comments on this article, please email them to
neil@reuk.co.uk.
Recommended Related Articles
People who read this article also enjoyed the following articles:
Making a Bridge RectifierFind out how to make a bridge rectifier for your wind turbine
Article Last Modified: 16:17, 22nd Mar 2007electronics | windBridge RectifierFind out more about bridge rectifiers.
Article Last Modified: 15:33, 2nd Feb 2007electronics | wind | waveThree Phase BasicsGet an understanding of three phase wiring in wind turbine alternators
Article Last Modified: 14:13, 19th Aug 2008wind | electric circuit | websitesStepper Motor BasicsLearn more about stepper motors and their use in RE electricity generation
Article Last Modified: 08:54, 4th Apr 2007wind | educationPermanent Magnet GeneratorBuild a wind or water power system with around a PM Generator
Article Last Modified: 15:43, 6th Apr 2010wind | hydroBuy 35A Bridge RectifiersBuy 35A 600V MB356 Bridge Rectifiers in the UK
Article Last Modified: 08:43, 30th Jul 2007electronics | windStar Delta Wiring for AlternatorsLearn about Star and Delta wiring for wind turbine and other alternators
Article Last Modified: 13:39, 10th Mar 2008education | wind | hydroExamining a Stepper MotorRead how easy it is to understand the wiring of a stepper motor
Article Last Modified: 08:58, 24th Mar 2007general | educationLM317 High Current Voltage RegulatorFind out how to build an LM317T based high current voltage regulator
Article Last Modified: 11:29, 17th Aug 2010electric circuit | electronics | general | educationDIY 2kW Wind TurbineRead about a home built 2kW wind turbine constructed from scrap
Article Last Modified: 07:46, 4th Oct 2007wind | recycling
|
|
|
